Posted by Lenord You can use the scope.exe software and circuitry that I sell. One big IF is the number of wires going to the motors. If you have 4 wires going to the steppers you have, they are bi-polar and can't be controlled by the circuitry. You will need to replace the steppers then. Take Care
on November 29, 2006, 6:04 pm, in reply to "Re: dob driver 2"
76.186.143.207
Jerald,
If they have 5, 6 or 8 wires, the circuitry can control the steppers as they are, no problem.
One of the advantages of this software and circuitry is the support that is available should you have trouble.
Lenord
--Previous Message--
: I really just need software that can control
: the scope i still have the hurst stepper
: motors from tech 2000 mounted on the scope
: and they work really well.
:
Message Thread:
« Back to thread